Y-type filter selection principles
- Transportation:
- Ocean, Land
- Port:
- chongqing
Your message must be between 20 to 2000 characters
Contact Now| Place of Origin: | China |
|---|---|
| Payment Type: | T/T |
| Incoterm: | FOB |
| Transportation: | Ocean,Land |
| Port: | chongqing,, |
The Y-type filter is an indispensable device for the pipeline series that transports media. It is usually installed at the inlet end of a pressure reducing valve, pressure relief valve, fixed water level or other equipment to eliminate impurities in the medium to protect valves and equipment. of normal use. This universal valve filter has the characteristics of advanced structure, low resistance and convenient sewage discharge. The medium used can be water, oil, or gas. The filter can be made according to user requirements. Its appearance is basically the same (Y-shaped). The interior is made of stainless steel, which is strong and durable. When cleaning is needed, just take out the detachable filter cartridge, remove the filtered impurities, and then reinstall it. It is extremely convenient to use and maintain. This filter has small size, fine filter eyes, low resistance, high effect, easy installation and maintenance, low cost, and interrupted sewage discharge time. For ordinary small models, it only takes 5-10 minutes. Generally, the water net and oil net are 100-300 mesh/cm2.
Y-type filter Y-type filter must be installed before the main machine water enters, before the water pump enters the water, and before the tap water enters the water. It is recommended to use a model with a larger pipe diameter than the main unit and a high-quality brand filter with a larger diameter. When installing, please note that the cleaning port faces downwards. When the installation space is limited, it can be installed at an appropriate angle downwards. Do not install upwards because it is inconvenient to clean. The Y-type filter needs to be cleaned according to local water quality conditions.
Y-type special valve filter selection principles
In principle, the inlet and outlet diameter of the filter should not be smaller than the inlet diameter of the matching pump, which is generally consistent with the inlet pipe diameter.
2. Nominal pressure:
Determine the pressure rating of the filter according to the high pressure that may occur in the filter line.
3. Selection of hole number:
The main consideration is the particle size of impurities to be intercepted, which is determined according to the process requirements of the media process. Check the table "Filter Specifications" for the particle sizes that various specifications of wire mesh can intercept.
Related Keywords
